Metpost Driving Tool
Product Code [GR-332]
Quantity
To ensure easy installation of Metpost Post Supports it is strongly advised that the Metpost Driving Tool is used. The tool protects the Metpost Post Support as you hammer it in and assists with its correct alignment.
The Metpost Driving Tool is manufactured from 96% reprocessed material.
Put up a fence in 6 easy steps:
- Mark out the line of your fence. Using a Metpost Driving Tool and a sledgehammer, drive in the first Metpost using short firm strokes.
- Every few strokes check the vertical alignment of the Metpost with a spirit level. Also take care that the Metpost doesn't "twist" out of alignment with the fence line.
- Adjust the alignment of the Metpost using the handles of the Metpost Driving Tool. Continue to drive in the Metpost until the box is approximately one centemetre off ground level.
- Attach Metclips or L Clips to the post using galvanised nails.
- Place timber post into box of spike and tap home right to the bottom and tighten the bolts until secure. Locate a panel into the Metclips and fasten with galvanised nails.
- Drive the second Metpost Post Support into the ground at the opposite end of the panel and repeat steps 2-6, erecting your fence as you go.
Size: 58mm x 180mm for a 75mm box OR 78mm x 190mm for a 100mm box.
Minimum purchase of 4 Metposts, any mix.
£25.00
Customer reviews
